18 | Sinterit SANDBLASTER XL User Manual
8. Troubleshooting
Fault symptoms
Possible Causes
Remedial actions
Excessive dust in the Sinterit
SANDBLASTER XL.
Blocked vent or airflow.
Clean the vent and keep it away from the wall.
Leakage at the pneumatic
connections.
Tighten up the connections and check that they
are all correct.
Too much Abrasive material in
the sandblaster.
Remove the excessive Abrasive material.
Inconsistent effects of the
Abrasive material.
Moisture in the sandblaster.
Replace the Abrasive material.
Incorrect speed or inefficient
sandblasting.
Abrasive material running out. Replace the Abrasive material.
Pressure too low.
Increase the inlet pressure and check that the air
regulator is fully open.
The nozzle does not turn off.
Incorrectly connected control
pneumatic tubings.
Connect the control pneumatic tubings properly.
Lack of integrity in the control
tubings.
A flow of abrasive is too weak.
The Static Nozzle is clogged.
1. Remove the ceramic nozzle and clean it with
compressed air.
2. Install it back.
A flow of abrasive is weak and
the nozzle has been cleaned.
1. Remove the ceramic nozzle, close the
sandblaster and start the abrasive flow.
2. This process should remove every object that
is in the air flowing duct.
3. Install the ceramic nozzle back.
Check if the Venturi tube
31
is correctly installed
in the Static Nozzle or if it is not clogged.
Check if the Venturi tube is correctly installed in the Static Nozzle or if it is not clogged.
ATTENTION!
Any other problems not described in this manual should be reported to Sinterit Support by
contacting through:
•
email: [email protected]
•
www: sinterit.com/support-page/
•
phone: +48 570 702 886.
9. General legal information
Where this manual refers to Sinterit or the Company, this means Sinterit sp. z o.o. with its legal seat in Krakow, registered
by the District Court for Kraków-Śródmieście in Krakow, XI Commercial Division of the National Court Register under
number: 535095, NIP (tax number): 6793106416, with the share capital for a date of publication of this manual of PLN
102,050 (say: one hundred and two thousand and fifty).
This document contains material protected under copyright and industrial property laws. This means that the document
may not be, including but not limited to, reproduced or modified without the consent of Sinterit.
This manual serves to assist you in the correct use of the device, perform basic maintenance and, if necessary, to solve
simple problems, allowing you to maintain the device in a good condition.
This manual contains content exclusively for the provision of information and the use by individuals professionally
trained and engaged in the operation and maintenance of the equipment described below.
The information contained in this document is intended for use only with the product called Sinterit SANDBLASTER XL.
Due to the constant development of Sinterit’s products the information contained in this manual, specifications and
markings are subject to change without notice.
