16 | Sinterit SANDBLASTER XL User Manual
1. Disconnect the sandblaster from the Power supply
12
and the compressor
14
.
2. Gently lift the sandblaster grid
24
and insert the rubber nozzle of the vacuum cleaner into the chamber.
3. Turn on the vacuum cleaner and remove all used Abrasive material, also clean the remaining parts in the chamber
(Air filter, pneumatic tubes, housing, Protective Rubber Gloves).
4. Gently transfer the whole contents of the vacuum cleaner into the sealed container. Treat it as industrial waste.
Dispose it in accordance with local waste management policy.
5. Take the container with the new Abrasive material open it and gently pour it in through the hole in the grid
24
. Add
not more than 10 kg / 22 lbs.
6. Connect the Power supply and the compressor.
STANDARD EXCHANGE OF ABRASIVE MATERIAL
WARNING!
A second person is required to help with the standard Abrasive material change.
The Sinterit
SANDBLASTER XL with the Abrasive weighs approx. 40 kg – improper maintenance (without the
help of a second person) an cause injury.
CAUTION!
•
The Inner chamber grid
24
is heavy!
•
Danger of crushing upper limbs when rising the Inner chamber grid.
1. Disconnect the sandblaster from the Power supply
12
and the compressor
14
.
2. Remove the grid
24
carefully from inside of the
sandblaster
9
. Put it on the work tray (so as not to
contaminate the workplace).
3. Prepare a container for used Abrasive material.
4. The plastic cork
27
for removing the Abrasive material
from inside the sandblaster is located in the middle of
the bottom (Image 9).
5. With the help of another person, slide half of the
sandblaster out of the worktop.
6. When one person is holding the sandblaster, the other
person must place the container under the bottom of
the sandblaster and unscrew the cork
27
.
7. When the contents of the sandblaster are poured to
the container, quickly insert the cork in place and move
the sandblaster to the workplace. Treat used Abrasive
material as industrial waste. Dispose it in accordance
with local waste management policy.
8. Take the container with the new Abrasive Material
open it and gently pour it in. Add not more than 10 kg
/22 lbs.
9. Put the grid in place. Be careful not to damage the
components inside the sandblaster chamber.
10. Connect the Power supply and the compressor.
27
Image 9. The position of the plastic cork for removing
used Abrasive material.
B. REPLACEMENT OF THE CERAMIC NOZZLE FROM THE INNER AIR BLOW GUN
1. Disconnect the sandblaster from the Power supply
12
and the compressor
14
.
2. Unlock the door
10
with the door ’s lock
7
and open it.
3. Remove the Inner Air Blow Gun
20
.
4. Unscrew the nozzle lock and pull the ceramic nozzle out of it.
5. Clean the Inner Air Blow Gun of any possible dirt and powder.
6. Insert the new ceramic nozzle
H
into the nozzle lock nut (the five spares ceramic nozzles are available in additional
accessories of the sandblaster. Remember, that they have different dimensions).
7. Tighten using the supplied wrench
F
. Put the Inner Air Blow Gun back into the sandblaster.
