First, shorten the silicone strap half without
the SINN logo. To do this, sever the silicone
strap with a knife or pair of scissors centrally
between the last metal pin and the stud in
the second-to-last position. After severing the
silicone strap, remove the stud and replace
it with a metal pin. Replace the stud at the
second-to-last position after first removing
the metal pin. Open the retaining bar on
the folding clasp and guide the shortened
silicone strap half with the stud from above
via the insertion slot into the guide rails of
the folding clasp. From the standard position,
the silicone strap can be move one position
forward or back (see diagram). Close the
retainer bar and try on the silicone strap.
If a further shortening is necessary, you will then need to carry this out on the
silicone strap half with the SINN logo. To do this, you will first need to remove the
folding clasp. After doing this, sever the silicone strap again with a knife or pair
of scissors – centrally between the spring bar and the metal pin. After severing
the strap, replace the outermost metal pin with the spring bar and then
reattach the folding clasp to the silicone strap (see
Step 3
). Try on the silicone
strap.
You can use this principle to make any additional shortenings that may be
necessary.
Standard position
Insertion slot
