STEP 1:
FITTING THE ADAPTER TO THE CASE
To fit the adapter to the case, you will need spring bars
A1
+
A2
(see
diagram) from the spring bar box and the enclosed band replacement tool.
Firstly, insert a spring bar fully into the longitudinal hole of the adapter. Next, from
the underside of the watch case, position the adapter between the band lugs
of the watch case and gently apply pressure to the adapter in this installation
direction using your thumb. Then, with the band replacement tool, press in both
ends of the spring bar, lying on the underside of the band lugs, sequentially
until the adapter can be slid forward into the end position. In this position, snap
the ends of the spring bars into the laterally visible holes in the watch case.
Repeat the process with the second adapter.
Please note:
On both adapters, the spring bars for fitting or removing the
silicone strap (see
Step 2
) are pre-installed. These spring bars were developed
specifically for DuoFlex and cannot be replaced by other spring bars.
Short side
Rim
Long side
A
B
C
STEP 2:
FITTING AND REMOVING THE SILICONE STRAP
A.
To fit the silicone strap, attach one half of
it, in parallel to the case back, to the pre-
installed spring bar on the adapter.
B.
Fold both halves of the silicone strap
upwards in the direction of the watch.
C.
For the other half of the silicone strap,
proceed as described above. To remove
the strap, repeat the process in reverse
order.
A1
A2
