sinmag SM-402, Инструкция по эксплуатации

Страница: 18 / 24

SINMAG SM-402 Mixer
W & P Reedy Pty Ltd 02-9533-9522
www.wpreedy.com.au
Page 16
Useful Information. (Cont.)
Lubrication.
The motor has grease packed ball bearings so will require little attention. The
transmission gearing is packed with special grease that will last for several years. Oil only
attachments when an attachment is in place and never use more than a drop or two.
Lubricate the bowl cradle sides occasionally by applying a small amount of oil or grease with
the tip of the finger. Only food grade synthetic oils are suitable for this type of lubrication.
The polished drip cup is a safe guard to prevent any lubricant that might work out of
the planetary gearing from dropping into the bowl. Remove the drip cup(by pulling straight
down) once a month and wipe it clean. ( This should only be done by a trained service
technician )
Attachments.
When fitting an attachment the bowl must be in the down position. Slip the
attachment up on the shaft and turn it until the driving pin in the shaft reaches the L-shaped
slot in the beater shaft. Attachments of various styles are available, each suited to a
particular job.
The beater is commonly used for thin batters, cakes, mashing potatoes, short pastry
and mixing of sausage meats, beater to be used in 1 and 2 speeds only. The whipping
st nd
ball is best for whipping cream and beating eggs, whisk to be used in 2 and 3 speeds
nd rd
only.. The dough hook is used for pastry, soft doughs, brioches and biscuits doughs, the
dough hook to be used
only in 1 speed. See below.
st
Always stop the motor before changing the speed of an attachment.