Singer Sani Steam Care SGR-20430, Инструкция по эксплуатации

Страница: 10 / 32

10
ENGLISH
completely.
5. Fill the boiler with approximately 300 ml of tap water. Close the boiler cap
and shake the base unit for a few moments. Then, empty it completely.
Important: To obtain the best result, we recommend that this operation be
performed twice. Before re-closing, make sure no water remains in the boiler.
6. If your appliance is equipped with scale collector (9*), it must be washed
(see the “Descaling the scale collector” section).
7. Replace and tighten up the cap.
Descaling the limescale collector *
1. Place the limescale collector (9*) under the water tap.
2. Wash it up until limescale residues are removed.
Descaling the iron
1. Fill the tank (10) with tap water.
2. Plug in the mains cable (7) and press the button (2) to switch the appliance
on.
3. Press the descaling button (3) for 2 seconds. Its indicator light will remain
permanently lit.
4. Wait until the indicator light (2) stops fl ashing and remains lit permanently.
Two beeps will be heard. Place the iron on the “Calc Clean” container (18).
Make sure that the surface on which the container is placed is stable.
5. Press the steam release button (15) for 2 seconds. The descaling process
will start automatically.
Warning: boiling water and steam will be released through the soleplate,
carrying limescale and/or deposits that may be inside.
During the process,
a beep will be heard every 5 seconds.
6. After approximately 3 minutes, the iron will stop releasing steam. A long beep
will be heard, indicating that descaling process has fi nished. The appliance
will switch off automatically.
7. To clean the soleplate (17), immediately rub off any residue by running the
hot iron over a wet cotton cloth.
2. Cleaning the appliance
Regularly clean your appliance for properly maintenance. Attention! Burn risk!
1. If the appliance is only slightly soiled, wipe it with a damp cotton cloth only,
and then dry it.