8
WATER SOFTENER MANUAL
MANUALE ADDOLCITORE ACQUA
CS3H - CS6H
6. TROUBLESHOOTING
APPEARANCE
Controll does
not work
Unsatisfied water
hardness
Water hardness
remains
Control backwash
at excessively low
or high rate
Softener fails
to use salt
Untread water
leakage during service
Incorrect time
of regeneration
Noisy
Milk white water
Leaking
Brine container overflow
POSSIBILITY
Transformer is not plugged in
Poor raw water quality
Fail to regenerate automatically
Water pressure is too low
Improper regeneration
Loose connecting
Resin disabled
Injector is plugged
Injector is plugged
O-ring around riser tube demage
Internal control leak
Incorrect regeneration cycle setting
Defective power cord
Time of regeneration is too long
Brine concentration is poor
Foreign matter affecting
controller operation
Brine line plugged
Leaking of bypass valve
Power off
Defective transformer
Power outage causes
inaccurate timing
Air exist in the system
Air exist in the system
Refill time disordered
Incorrect backwash controller used
According to the user manual
to reset the timer
Call your dealer
Re-Backwash the system to vent air
Turn on the tap to vent air
Connect to constant power surce
Call your dealer
Check power of controller
Replace with correct size controller
Line pressure must be
at least 20 psi
Repeat regeneration making certain
thet the correct salt dosage in set
Tighten joints
Re-regeneration or use new resin
Disassembled the injector and
clear it by washing with water
Clean or replace injector
and screen
Check piston, seal and spacers
Reset regeneration cycle
Replace cord
Reset time of regeneration
Keep brine tank full of salt
Remove controller and ball.
Flush with water
Clean brine line
Replace O-ring
Just wait for power on
Replace the transformer
SOLUTION
