6.6. DECOMMISSIONING
During long periods of inactivity it is necessary to:
- Disconnect the power supply from the gener-
al electrical panel and all other power supplies
(pneumatic and/or hydraulic) which the machine
needs.
- Perform all maintenance operations.
- Accurately clean the machine.
- Store the machine in a protected area with a sta-
ble support surface.
- Cover the machine to avoid dust accumulation.
-
Make sure that the environmental conditions are
suitable for preserving the machine over time.
7. MAINTENANCE
7.1. MACHINE ISOLATION
Before carrying out any type of Maintenance or Re-
pair, it is necessary to isolate the machine from the
power supply and from all other energy sources pres-
ent.
7.2. SPECIAL PRECAUTIONS
When carrying out any maintenance or repair work,
the following recommendations should be followed:
• Before starting work, display a sign stating "MA-
CHINE UNDER MAINTENANCE" in a visible spot;
• Do not use flammable materials or solvents;
• Be careful not to pollute the environment with
coolants;
• To access the highest parts of the machine, use
the appropriate means and procedures;
• Do not climb on the machine parts, as they are not
designed to support people;
• When finished, refit and properly secure all safety
guards and devices that may have been removed
or opened.
IMPORTANT: The Manufacturer cannot be held li-
able for the failure to comply with the aforemen-
tioned recommendations nor for any other use
that is inconsistent or not mentioned in these in-
structions.
7.3. CLEANING
Before carrying out any cleaning operation, discon-
nect the device from the mains and from the energy
sources present.
Do not use corrosive cleaning products, flammable
or containing substances harmful to health.
Make sure that the parts being cleaned are complete-
ly cold.
Do not wet the internal parts to avoid damaging the
electrical and electronic components.
Do not direct any jets of compressed air directly on
the electrical and electronic components so as not to
damage them.
ATTENTION: Always use the appropriate PPE such
as gloves, mask, glasses according to current safe-
ty standards.
1.995.232 EN - Rev. 1.1
NOVACUT 106 LCD
28
