I ndoor unit installation
Precautions: B e sure to connect the indoor unit and outdoor unit at r ight poles.
Installation of panel
1.Set the panel to the indoor unit body by matching the position of the swing flap motor of the decoration panel to the
piping position of the panel to the piping position of the indoor unit as shown in fig.4.
2.Install the decoration panel
(1) Hang the latch,which is located on the opposite side of the swing flap motor on the panel,temporarily to the book
of the indoor unit. (2 Positions)
(2) Temporarily hang the remaining 2 latches to the hooks on the sides of the indoor unit.(be careful not to let the swing
motor lead wire get caught in the sealing material.)
(3) Screw all 4 hexagon head screws located right beneath the latches in approximately 15mm.(panel will rise)
(4) A djust the panel by turning it to the arrowed direction in Fig.4 so that the ceiling opening is completely covered.
(5) Tighten the screws until the thickness of the sealing material between the panel and the indoor unit body is reduced
to 5 8 mm.
In
d
oo
r
u
n
it
in
st
al
la
ti
on
31
32
