Sinbo SHC 4353, Инструкция по эксплуатации

Страница: 9 / 56

- 8 -
oxygen is being administered.
• Make sure the cord is disconnected from the hair clipper while storing this appliance and
cord in a moisture-free area. Do not store it in temperatures exceeding 60°C (140°F).
• Do not use this appliance with a damaged or broken cutter unit, as injury may occur. Always
make sure blades are aligned properly.
• Always attach plug to appliance and then the adaptor to the outlet. To disconnect, turn all
controls to OFF, then remove adaptor from outlet, then detach power cord from the hair clipper
for storage.
• Do not use an extension cord or a voltage converter with this appliance.
• Do not wrap the cord around the appliance.
SAVE THESE INSTRUCTIONS
FEATURES
• Stainless steel blades
• With Blade adjustable level and hanging loop
• With 4 positions detachable comb 3,6,9,12mm
• Reduced vibration and noise
• Power supply: AC230V, 50Hz, 8W
• With 1 x cleaning brush, 1 x blade protective cap
BEFORE CUTTING HAIR
The blades of this clipper are designed to remain permanently lubricated. They do not need
oiling. We have aligned the blades on your hair clipper prior to shipment. It is possible the
blades may be bumped out of alignment whilst in transit. Correct blade alignment is essential
for effective cutting.
Compare the blade position on your hair clipper with the images shown on the left. If the blades
are out of alignment they can be easily adjusted.
1. The end of the top blade should be closer to the body of the hair clipper than the bottom
blade. This is important so that the clipper doesn't cut too close or allow the moving (top) blade
to touch the skin.
2. The bottom blade should be as closely aligned as possible to the centre of the top blade.
3. If the blades are not correctly aligned, turn the clipper on for a few moments, turn off and
unplug. Loosen the two screws slightly and manually adjust the bottom blade until it is aligned.
Re-tighten the screws.
4. Ensure the hair clipper is running smoothly, with a slight vibration, before attempting to cut
any hair.
GETTING STARTED
1. Make sure your clipper is operating correctly.
2. Place a cape around the neck of the person whose hair is being trimmed or cut.
3. This person should be seated so that the top of their head is at your eye level.
4. Comb the hair as it is normally styled.
5. Comb out all knots and tangles.
6. Hold the hair clipper In the palm of one hand and with your thumb resting firmly on the top
of the hair clipper. This grip proves comfortable cutting control. Although the hair clipper be
used left or right handed, using it right handed allows you to access the taper lever more easily.