Distributed by:
Simx Limited
Ph: +64 9 259 1660 | Technical Support Ph: +64 9 259 1662
Email: [email protected] | www.simx.co.nz
Simx reserves the right to alter technical speci
fi
cations without prior warning
PUB1447 06/18
PRODUCT COMPLIANCES
Product tested and complies to:
IEC 60598-2-1:1979 + A1:1989, IEC 60598-1:2014, EN60598-2-1:1989, EN 60598-1:2015
EN 62031:2008 +A1:2012+A2:2014, EN 62031:2008 +A1:2013 +A2:2015
EN 62493:2015, IEC/TR 62778
MANUFACTURERS
WARRANTY
This product is guaranteed by SIMX Ltd for 36 MONTHS from the date of purchase against faulty
materials or workmanship which affects its designed ability to operate. During this period if the
product has a defect of this nature it will be repaired or replaced free of charge by SIMX with the
same item, or a similar item, or a similar one of higher specifi cation. ON CONDITION THAT:
-
The buyer returns it to the seller from whom it was bought, freight paid.
-
The product has been bought by the user. ie a receipt/sales invoice is produced as proof of
purchase.
- The product has not been misused or handled carelessly, installed in anyway contrary to the
installation instructions, or installed in any unusually exposed or harsh environmental
conditions.
This guarantee excludes liability for discolouration of paint or plastic, or any user replaceable parts.
It does not confer any rights other than those expressly set out above and does not cover any
claims for consequential loss or damage.
Our Goods come with guarantees that cannot be excluded under the Australian and New
Zealand Consumer law. You are entitled to a replacement or refund for a major failure and for
compensation for any other reasonably foreseeable loss or damage. You are also entitled to have
the Goods repaired or replaced if the Goods fail to be of acceptable quality and the failure does
not amount to a major failure.
Installation Method
•
Unclip the front decorative cover attached to the base unit from the top.
•
Using the luminaire as a mounting template, locate the fi tting against the desired mounting
location and mark the wall through the mounting holes. Drill appropriate diameter holes in
the wall to suit the mounting screws supplied.
•
Remove the clear front lens from the luminaire. Pierce the centre of the cable entry gland,
and feed power supply cable through this and wire to the terminal block
(Brown is L and Blue is N). Failure to maintain polarity may result in irrepairable damage to
the light. Note to retain IP rating, round core cable must be used.
•
Resecure the clear front lens to the unit fi rmly using the screws supplied.
•
Locate luminaire over the pre-drilled mounting holes, and fi x unit fi rmly to the wall.
•
Switch on power supply and test operation.
•
Reattach the front decorative cover supplied and click into place.
INSTALLING YOUR MAXI WASHER
This luminaire, rated to IP55, is designed for wall mounting only and is suitable for permanent
outdoor use.
Ensure the desired location does not exceed this rating. Switch off the power supply before
commencing electrical work. We strongly recommend this light fi tting is installed by a registered
electrician.
INSTALLING YOUR MAXI WASHER
