BEFORE YOU INSTALL YOUR FLOODLIGHT
This floodlight should be installed by a Registered Electrical Contractor.
Fig A
Before installing this floodlight, please be aware of the following caution notes:
• This light fitting is rated to IP44. This means that it is suitable in areas which may receive light
rainfall. Please ensure the desired location does not exceed this rating.
• This floodlight should not be mounted to any surface that may be prone to vibration.
Floodlight is designed to operate correctly with horizontal lamp orientation only.
• Warning: This floodlight must not be mounted in exposed areas where wind gusts are expected
beyond 130km/hr.
• The housing will be HOT to the touch during operation. Allow sufficient time for the unit to cool
before making any adjustments or replacing the lamp. Only touch the lamp with a soft clean
cloth when fitting and replacing the lamp.
• Care and consideration should be taken when the unit is located close to property boundaries,
to avoid unnecessary spill light or glare to neighbours, or to passing pedestrians and/or vehicles.
INSTALLATION METHOD
Switch off and isolate the power supply before commencing any electrical work
Select a suitable location for your floodlight. Recommended mounting height is 2.0 - 3.5 metres.
Remove the bracket from the housing, and using the bracket to mark the position of the screw
holes on the mounting surface, drill the holes. Tension the bracket 5nm to the mounting surface.
Care should be taken to avoid drilling or screwing into concealed wiring.
Remove the rear cover of the junction box. Carefully draw a round core mains power cable through the
power entry gland and into the junction box (refer to FIG. A).
Wire the mains cable to the terminal block (refer to FIG. B) ensuring accurate polarity. This floodlight
must have an Earth connection for safety. Secure cable with anchorage. Refit the junction box
cover and tighten the power entry gland.
Unscrew the front lamp cover, and insert the lamp supplied. Refit the front lamp cover. Use a soft
clean cloth when handling the lamp.
Fit the floodlight body to the mounting bracket.
Aim the floodlight and tension the bracket pivots to 5nm.
Reconnect power supply.
Fig B
Replace any cracked glass immediately
using only 5mm tempered glass.
A minimum distance of 1 metre from any object
in front of the floodlight must be observed.
ICON KEY
