Simrad GC80 Compact MK2, Руководство пользователя, Страница: 76 / 156

Simrad GC80/85 Dual MK2 Gyro Compass
988-12720-002 62
6.7 System start-up and software configuration
When all GC80/85 units are installed and the cables connected according
to the procedures described in previous chapters, the system is ready for
the first time start-up procedure.
Note! The start-up procedure and configuration is identical for each Gyro, and
has to be performed for both Gyro compasses before the Dual function
can be started. The start-up procedure may be performed simultaneously
for both compasses.
System Start-up for each Gyro compass
1 Turn ON the Gyro system by pressing the POWER button on the
Control panel. Follow the start-up sequence:
- Control unit type (GC80 Std, or GC85 HSc), software version for
Control unit and for Master compass is displayed in rapid succession.
Examples of display texts are shown below:
OR
GC80 CONTROL
UNIT
STD VERSION
GC85 CONTROL
UNIT
HIGH SPEED
VERSION
SOFTWARE VERSION
CONTROL UNIT
SOFTWARE VERSION
MASTER COMPASS
GYRO
2 The Sensitive element starts rising horizontally, and the compass
turns 360° clockwise. The display shows decreasing bearing as the
compass is turning.
3
If the Gyro has been turned ON and OFF again, but the rotor is still
rotating when the
POWER
button is pressed for new start, a rotor
break function will be activated to completely stop the rotor.
4 Active rotor break is indicated with flashing display.
GYRO
5
When the rotor rotation has stopped, start bearing is indicated with
flashing text in the display. The start bearing will be the same as
active bearing when the compass was turned OFF.