Simrad EC150-3C, Руководство по установке

Страница: 91 / 150

438371/A
89
4 Pull the cable through the cable gland.
5 Push the sealing in under the braided shield.
6 Tighten the sealing nut.
7 Thread a ferrite core onto the cable.
Place the ferrite core as close to the cable gland as possible. Secure it with a cable
tie.
8 Connect the red and grey power cables to the terminal block.
Signal Colour Terminal block
+12 VDC Red Fuse
Ground wire Grey 1
9 Thread a ferrite core onto the outer jacket of the signal wires.
Secure it with a cable tie.
10 Remove the outer jacket from the signal wires.
11 Separate the twisted pairs used for Ethernet and synchronization.
12 Thread heat-shrinkable tubing onto the wires for protection.
13 Connect the synchronization wires to the terminal block.
Signal
(Transducer)
Colour
(Transducer cable)
Terminal block
Sync IN (-) Black
6
Sync IN (+) Green
7
Sync OUT (-) White 9
Sync OUT (+) Blue 10
14 Thread a ferrite core onto the Ethernet wires.
Place it as far away from the Ethernet socket as possible. Secure it with a cable tie.
15 Connect the wires to the Ethernet socket.
Cable layout and interconnections