Simrad EC150-3C, Руководство по установке

Страница: 120 / 150

118
438371/A
This procedure is made for the Microsoft ® Windows ® 7 operating system.
a In the bottom-left corner of your desktop, select the Windows
®
Start
button.
b On the right-hand side of the
Start
menu, select
Control Panel
.
c Observe that the Control Panel opens.
d Select
Network and Sharing Center
.
(If the Control Panel is shown with categories, select
View network status and
tasks
.)
e On the left-hand menu, select
Change adapter settings
.
f Click once on your network adapter to select it, then right-click and select
Properties
on the shortcut menu.
g On the list of connections, select
Internet Protocol 4 (TCP/IPv4)
, and then
Properties
.
3 Select
Use the following IP address
, and type the IP address and network mask.
•
IP address
: 157.237.15.12 (Recommended)
•
Subnet mask
: 255.255.255.0
You can leave
Subnet mask
blank and select
OK
. When you see an error message
saying that the message subnet mask is missing, select
OK
again. A default subnet
mask is then automatically generated.
4 Select
OK
to save the selected settings, and then close all the dialog boxes.
Further requirements
If you later need to change the IP address, always recycle the power to the EC150-3C
before you start the EK80.
Functional test of the EC150-3C Transducer
A brief functional test is used to verify that the EC150-3C is operational.
Prerequisites
The EC150-3C hardware units are installed as specified in this manual.
• The EK80 is turned off.
Caution
You must never set the EK80 to "ping" unless the transducer is submerged in water.
The transducer may be damaged if it transmits in open air.
• All relevant channels (transceiver/transducer combinations) are installed in the user
interface.
Simrad EC150-3C Installation Manual