CR40/42/50 MKII Fundamentals & initial start-up
Chapter 2
15
2.6 Naming of routes, points, etc.
First select the key with the desired letter, then you can either repeat
the keystrokes, which will toggle between e.g. A,B,C,1, or once you
have selected one letter you can go back and forth in the alphabet by
means of the +/- keys. Use the cursor key to go to next space or to go
back one space if you make a mistake.
Depending on the selected language the 0 (zero) key will hold special
characters e.g. Æ Ø Å Ä Ö Ü Ñ, and the 9 (nine) key will hold: (empty
space) . -
Press the
[CLR]
key to delete everything from cursor position and to the
right of cursor on that row.
2.7 Initial start-up
PWR
To turn on the power, press and hold the
[PWR]
key till a picture
appears on the screen
PAGE
Press
[PAGE]
to scroll through a quick guide which informs of the use
of the keys and where you can enter owner’s setup
ENT
Press
[ENT]
when ready to assume normal operation
PWR
Press
[PWR]
again to adjust the lighting in the screen and select day or
night display, etc., move around in display by means of the cursor key
and change settings with +/- keys, and…
ENT
Confirm with
[ENT]
The unit will now perform a fully automatic start-up and find the cor-
rect position without further data entries. The start-up phase is com-
pleted when a position appears in the position display – see section 4.1.
The radar function should not start transmission before the antenna is
properly warmed up - refer to section 7.2.3 Start transmission.
Содержание CR40 MKII
Страница 50: ...CR40 42 50 MKII Position menus Chapter 4 50...
Страница 120: ...CR40 42 50 MKII Installation and service Chapter 9 120 Other important settings continued...
Страница 160: ...CR40 42 50 MKII Glossary of terms Appendix A 160...
Страница 174: ...CR40 42 50 MKII DGPS ChartRadar Index 174...
