Simrad 398445, Руководство по установке, Страница: 31 / 66

404776/A
29
The force of the water when the hull falls down may push the transducer up, and may cause
damage both to the transducer and to its mounting.
Note
Kongsberg Maritime AS takes no responsibility for any damages to the transducer, the cable
or the mounting arrangement, caused by slamming.
A
Bolt with suitable diameter
and length
B Nut
C
Washer
D
Transducer cable
E Hull
F
Fill with suitable filling
compound (putty) to reduce
flow noise
G Tarred felt
Procedure
1 Lift the transducer up into is
location, and align the holes
on the transducer with the holes in the fairing.
Note
Observe the direction of the transducer. The "forward" marking must point towards the
bow of the vessel!
2 Insert the two bolts through the transducer, fairing and hull plating.
3 Fasten the two nuts on the inside of the hull.
Use Loctite to secure the nuts.
4 Fill the two bolt holes in the transducer with a suitable filling compound (putty), and
smooth out the surface of the transducer face.
Note
Any obstructions, cracks, dents or unevenness on the transducer face may cause flow
noise.
5 When the transducer has been secured, inspect the hull area around the transducer face.
Installing the transducer