Simpson SWT1012A, Руководство пользователя

Страница: 7 / 24

However, due to the variables of fabric types, soil
levels, detergent types and available program
settings you may find some combinations of these
which do not always result in the perfect wash.
If for example you see residuals of detergent or
soils on some items, please read the section
Residues on washed items paragraph.
Each load of washing should contain clothing which
needs the same washing conditions. For example,
you should not wash delicate clothes with very dirty
work clothes.
Some fabrics are lint collectors and can pick up lint,
dirt and colour from other fabrics, which are lint
producers. Some examples are listed below.
Empty all pockets. Close all hooks and zippers to
avoid snagging clothes. Wash bras, pantyhose and
other delicates in a mesh laundry bag which you
can purchase from your supermarket.
IMPORTANT: Pre-treatment sprays and stain
removers can damage plastic components on your
washing machine. If you use pre-treatment sprays or
stain removers, apply them to the clothing well
away from your washing machine.
Make sure that you wash lint collectors separately
from lint producers.
Over time you will learn what is the best set-up of
programs, detergent and load sorting for different
load types and soils.
Button Response and Lights
Lid Soft Landing Feature
4
Simpson Washing Insructions
Sort Your Washing into Separate
Wash Loads
Lint Collectors Lint Producers
Corduroy Towels
Synthetics Nappies
Permanent press fabrics Chenille / Candlewick
Check Your Clothes to Avoid
Damage
Pre-Treatment Sprays and Stain
Removers
These Washing Instructions are of a general
nature and you should get good wash results
by following them.
If an out of balance occurs, the machine may stop
spinning and then start spinning again to try and
overcome the out of balance before alerting you
with “beeping”.
To rectify the out of balance condition, open the
lid and redistribute the clothes evenly in the
washbowl.
Closing the lid will start the machine and continue
the wash program.
If you have frequent out of balance interruptions, it
may be due to your washing machine not standing
firm and level on the floor.
This can be corrected by adjusting the washing
machine legs as described in the Installation
instructions supplied with your machine.
Always touch the buttons gently. Watch the lights
on the control panel to see the effect of touching
a button, and listen for “BEEPS”.
When you touch a button you will get a short
“BEEP” to acknowledge the entry. If the option is
not available at the time, a long “ERROR BEEP”
will be heard, the message “ ” is displayedfor
about 2 seconds
NOTE: All functions of the washing machine will stop
when the lid is opened.
You will have to wait for the lid to unlock before
opening the lid. The lid is unlocked when the
padlock symbol in the screen disappears.
Out of balance is caused by an uneven distribution
of clothes in the washbowl.
Caution
ERR
To close the lid from fully opened position, close
the lid as usual. The lid will slowly close down on
its own.
The lid soft landing feature will only work
from fully opened position. It will not work
if the lid is opened less than 80 degrees and
closed. To avoid injury, do not put your
hands under the lid in case the lid will close
rapidly.