Simpro QUIKSTAK QS10MM, Руководство пользователя

Страница: 14 / 52

1. Drive the Quikstak to the pallet which is to be collected. Approach the pallet from a
90-degree angle, with the forks and outriggers aligned so as to avoid striking
obstacles or internal cross-members.
2. When close to the pallet, use the RAISE and LOWER buttons to adjust the forks the
correct height.
3. Slowly drive the Quikstak directly forward so that the forks traverse inside the pallet.
Take care that the outriggers do not strike obstacles at ground level.
4. Press the RAISE button to lift the pallet a short distance.
5. Reverse the Quikstak with the pallet, again taking care to avoid obstacles. The pallet
can now be transported to the desired destination.
Only transport pallets that are balanced and centrally positioned on the forks. Do not
allow other persons to approach within 2 metres of the stacker while carrying a load.
A CRUSH SAFETY button is fitted to end of the control tiller as per 2.1.1
⑤
. If this button is
pressed against the operator’s body while reversing, the Quikstak will immediately stop
and drive a short distance forward to prevent injury.
6. At the destination, manoeuvre the Quikstak so that the pallet is located above the
point where it is to be deposited.
7. Press the LOWER button to deposit the pallet into place.
8. Once the pallet is deposited, briefly press the RAISE button to lift the forks ~10mm.
9. Slowly reverse the Quikstak in a straight line until he forks are completely disengaged
from the pallet. The Quikstak may now be driven and used elsewhere.
If the Quikstak stops working or behaves abnormally, it should be slowly driven or towed
to a safe location and parked. It should not be used again until the fault has been
diagnosed and repaired by an authorized service technician.
2.5 Using the Quikstak height-levelling system
The Quikstak is fitted with an automatic height-levelling system, which automatically adjusts
the height of the forks while stacking goods, to maintain an ergonomic working height.
2.5.1 Stacking goods
1. Collect a pallet on the forks as per §2.4, then drive the Quikstak to the stacking
location (for instance, end of a production line or beside a conveyor belt).
2. Manually adjust the forks to an ergonomic height for stacking goods onto the pallet.
a. The most ergonomic stacking height is around the same level as the
operator’s waist, typically between 1m and 1.2m high.
b. Ideally the pallet should be positioned slightly lower than the surface from
which the goods are being taken.
c. The Quikstak should be positioned so that goods can be stacked with a
minimum of lifting, bending, stretching, or reaching.
3. Press the TEACH HEIGHT button ( §2.1.3
⑫
) and wait for 5-10 seconds while the working
height is measured and stored to memory.