Simpro QUIKSTAK QS10MM, Руководство пользователя

Страница: 12 / 52

2.2 Before use
Before operating the Quikstak, carry out the following checks to ensure it is ready to use.
1. Check that the batteries are charged.
a. Pull out the EMERGENCY STOP button ( §2.1.3
⑩
).
b. Insert the key ( §2.1.2
⑥
) and turn clockwise to enable the power.
c. Check the battery indicator ( §2.1.2
⑦
) on the fascia of the stacker. If the
batteries are flat (the first or second LEDs are illuminated), the Quikstak should
not be used. It should be placed on charge as soon as possible, as per
§2.7 .
2. Check that the stacker is in good operating condition.
a. No obvious oil leaks.
b. No warning lights, strange sounds, or other unusual indications.
Once these checks are completed the Quikstak may be placed into operation.
2.3 Moving the Quikstak
2.3.1 Driving
The control tiller is used to control the travel direction and speed of the Quikstak. To drive the
stacker, the tiller must be positioned within the zone marked
READY in the diagram below.
When the tiller is positioned in either of the zones marked BRAKE , the stacker cannot be
driven, although the RAISE and LOWER functions are still available.
1. To drive forwards, move the tiller
into the
READY zone and rotate
the DRIVE LEVER ( §2.1.1
③
) in the
direction marked FWD in Figure 6.
Rotate the lever further to drive
faster, and less to drive slower.
Release the lever to stop the
stacker by regenerative braking.
2. To drive backwards, move the
tiller into the READY zone and
rotate the DRIVE LEVER ( §2.1.1
③
)
in the direction marked BWD in
Figure 6. Rotate the lever further
to reverse faster, and less to
reverse slower. Release the lever
to stop the stacker by
regenerative braking.
BRAKE
BRAKE
READ
Y
Figure 6