Simpro Multi-Tip MT1600B, Руководство пользователя

Страница: 26 / 48

5. Care and Maintenance
The Multi-Tip is designed to give many years of service with minimal maintenance. In the
event a fault or malfunction does occur, refer to the
Quick Trouble Shooting Guide in Section
5.1 before contacting your agent for service. A Service Manual giving testing and repair
instructions is available on request from Simpro.
Contact your Simpro agent if repair or service work is required.
All repair and service work must be carried out by qualified personnel.
Replacement parts must be supplied by Simpro or an authorized Simpro agent, and must
be of the same design and specification as the original parts.
A detailed Service Manual giving specific testing and repair instructions is available on
request from Simpro.
5.1 Quick Troubleshooting Guide
Please refer to the Quick Trouble Shooting Guide below before requesting technical support.
Problem Possible Causes Remedy Reference
The machine
will not lift
bins, and the
motor does
not run
Flat Battery
Battery should be charged if the
indicator shows less than 12.2 volts.
5.4.3
Blown fuse, faulty
power lead or plug Check and rectify. The fuse may blow if
the machine is used with a flat battery.
5.4.8
Faulty switch or
wiring Check and rectify; contact your agent
for replacement parts if necessary
Faulty raise relay or
contactor
he ch e sh e ‘c ck’ s
when the SAFETY and RAISE buttons are
pressed
– if not, check the motor relay
and replace if necessary
The machine
will not lift
bins,
although the
motor runs
Bin too heavy Remove material to reduce bin weight. 5.3.1.1
Pressure-relief valve
set too low Contact Simpro for instructions on how to
adjust the pressure-relief valve
5.7.2.2
Motor running wrong
direction (3-phase)
Swap phase wires in the power plug 5.5.1
Cradle will
not come
down from
the fully
raised
position
Mast slider frame
jamming in mast Lightly lubricant inside of mast, slider
block and rollers with silicone spray
5.3.2
Lift ram jamming Contact your agent for instructions 5.3.2
Faulty switch, wiring,
or lowering valve
he ch e sh e ‘c ck’ s
when the SAFETY and LOWER buttons are
pressed
– if not, check the switch, wiring
and lowering valve
5.3.2
Cradle jams
part way
down
Mast bent or
damaged Check and straighten; contact your
agent for replacement parts if necessary
5.3.2
Tip guide flap
sticking or damaged Check and rectify; contact your agent
for replacement parts if necessary
5.3.2