SimpliFire • SF-SCT43-BK, SF-SCT55-BK Service Manual • 2043-960 • 7/20
6
Figure 17
Figure 19
COUPLERS
LED Assembly Replacement
1. Remove glass, see Glass Front and Glass Side
Panel Removal/Replacement.
2. Access internal components, see Accessing Internal
components instructions.
3.
Only when replacing back LEDs
: Refer to Rotis-
serie Assembly and Rotisserie Motor Replacement
steps 3, 4 and 7 to gain access to rear LEDs.
4. Remove screws holding the glass retainer/ember bed
bracket. See Figure 15.
Figure 20
Figure 21
= CONNECTORS
= CONNECTORS
BARBED CLIPS
BARBED CLIPS
CLIPS
CLIPS
COVER PANEL
LED Assembly Replacement (Continued)
5. Remove the rear LED cover panel by removing the
screws. See Figure 20.
6. Locate Lighting LED circuit input power source con-
nectors in rear of opening, unplug the two connec-
tors. Unplug the connectors between the LED circuit
boards. See Figure 21.
7. Using a pliers, compress each barbed clip along the
front base circuit boards while lifting the boards
evenly to disengage them from the clips. Use pliers
to open/spread clips along rear LED strip while lifting
to disengage it from the clips. See Figure 21. Re-
move all LED circuit boards.
8. Install the new LED circuit boards by securing them
in the clips. See Figure 2.
9. Connect all lighting LED power source connectors to
the LED circuit boards. See Figure 20.
10. If removed, reinstall the Rotisserie Rod Assembly
per Rotisserie Assembly and Rotisserie Motor
Replacement.
11. Re-install the rear LED cover panel. See Figure 20.
12. Replace the glass retainer/ember bed bracket. See
Figure 15.
12. Re-install flame screen. see Flame Screen
Replacement instruction.
13. Re-install components removed to access internal
components, see Accessing Internal components
instruction.
14. Re-install Glass. Per Glass Front Replacement.
COUPLERS
COUPLERS
CONNECTOR
CONNECTOR
Figure 18
SCREWS & NUTS
SCREWS & NUTS
MOTOR
MOTOR
BRACKETS
BRACKETS
