SimpliFire SF-SCT43-BK, Руководство по обслуживанию

Страница: 4 / 8

SimpliFire • SF-SCT43-BK, SF-SCT55-BK Service Manual • 2043-960 • 7/20 4
Accessing Internal Components (Receiver,
Flame Screen, Rotisserie Assembly, Ember
Bed Cover, Glass Screen Panel, Rotisserie
Motors, Flame and Ember Bed LEDs)
1. Remove glass, see Glass Front and Glass Side
Panel Removal/Replacement instructions.
2. With the logs/media removed, remove screws
holding the plastic ember bed cover down. Lift the
cover out of the appliance. See Figure 10.
3. While supporting the glass screen panel remove the
screws (4) in the glass screen panel bracket. See
Figure 11.
4. Tip the top of the glass forward and carefully lift the
glass out of the appliance.
5. When replacing glass screen, slide the over side
glass into the slot between the two brackets and tip
the glass back in place.
6. Reinstall glass panel bracket with four screws. See
Figure 11.
7. Reinstall ember bed cover with either 16 or 18
screws. See Figure 10.
Figure 10 Ember Bed Cover
Figure 11 Glass Screen Panel Removal
4 SCREWS TO BE REMOVED
(only two screws shown)
BRACKET
Remote Receiver Replacement
1. Remove glass, see Glass Front and Glass Side
Panel Removal/Replacement instruction.
2. Access internal components, see Accessing Internal
Components instructions.
3. Using a pliers, compress each barbed clip while
lifting the Remote Receiver Board evenly to
disengage it from the clip. See Figure 13.
4. Disconnect the receiver cable. See Figures 12 and
13.
5. Carefully align the new Remote Receiver Board
to the barbed clips and gently push in place. See
Figures 12 and 13.
6. Securely reconnect the wiring harness to the new
remote receiver. See Figure 12.
7. Re-install components removed to access internal
components, see Accessing Internal components
instructions.
8. Re-Install glass per Glass Front and Glass Side
Panel Removal/Replacement.
Figure 12 Receiver Location and Cable
RECEIVER RECEIVER
CABLE CABLE
Figure 13 Receiver Removal
BARBED BARBED
CLIPS CLIPS