7
SimpliFire • SF-BI30-E, SF-BI36-E Service Manual • 2040-910 • 8/13
Faux Flame Motor/Rod Kit (continued)
34. Install and tighten the screw in each end of the grate.
See Figure 2.
35. Install rubber plugs into holes in each end of grate.
See Figure 2.
36. Install glass into bottom retainer channel.
37. Install C-channel on top edge of glass panel.
38. Align C-channel with screw holes in appliance.
See Figure 1.
39. While supporting glass, install both screws through
top C-channel retainer into appliance.
40. Install front by aligning the tabs on its back side with
the spring clips on the face of the appliance. Press
evenly with two hands to fully engage the front to the
appliance.
Figure 1 Top Glass Retainer Screw Location
Figure 2 Grate and Log Screw Location
Figure 4 Removal and installation of LED access panel
Figure 3 Light LED Connection on Bottom of Log Ember Bed
Figure 5 Barbed Clip Access during LED Circuit Board
Replacement
Mounting Bracket Replacement
1. Install the mountng brackets (4) by aligning them
with the pre-drilled holes located on the side of the
appliance. Use two screws (ST4 x 8) per bracket to
secure to the appliance. See Figure 18 and 19.
