Cantilever Mounting – Single or Double
The following is a recommended procedure for cantilever mounting. This
procedure requires a mounting kit, model ON4TKIT or ONT6KIT.
Determine the clock mounting location.
1.
Using the template provided, mark the location where the clock is to
be mounted, making sure the center is located over the data cable
outlet.
2.
Using a #2 Phillips screwdriver and a 3/8” (.952 cm) wrench,
assemble the Ethernet Clock Mount (Simplex p/n 714755) and the
Ethernet Clock Cantilever Wall Mount (Simplex p/n 714756) as
shown in the illustration in Section 4 of this manual. Join the parts
using the 2 screws, 2 washers, and 2 nuts provided. Make sure that
the 2 washers are fitted between the Clock Mount and the
Cantilever Wall Mount.
3.
Insert enough data cable through the center hole of the mounting kit
so that it protrudes10 to 12 inches (30 cm).
©2007 Simplex Time Recorder Co. All rights reserved.
Page 13
