Pendant Mounting – Single or Double
The following is a recommended procedure for pendant mounting. This
procedure requires a mounting kit, (model ONT4 KIT for four digit clocks or
ONT6 Kit for six digit clocks), and some additional hardware.
PROCEDURE
Determine the clock mounting location.
The illustration above suggests a recommended mounting means for a
pendant mount of one or more Simplex Ethernet Clocks. Supplement the
ONT4 KIT or ONT6 Kit with two suitable locknuts and a length of ¾ “
(1.905 cm) pipe or conduit. If conduit is required, it’s a good idea to
measure and cut to length before beginning the installation.
1. Mark the location where the clock assembly is to be mounted, making
sure that the mounting means is located beneath the data cable outlet.
2. Assemble and tighten the locknuts and pipe length as shown above.
3. Insert enough data cable through the center hole of the mounting kit
so that it protrudes10 to 12 inches (30 cm). Securely attach the
mounting means using fasteners suitable for the surface.
4. Lift the
Simplex Ethernet Clock
into position and insert the data
cable into the jack located on the back of the clock.
©2007 Simplex Time Recorder Co. All rights reserved.
Page 11
