10 Programming and configuration
10.1 General information
1. Connect the SmartOutput module with a SmartRelay.
2. Connect the components to the power supply.
3. Programme the controller.
NOTE
The SmartOutput module can only be programmed on the controller.
10.2 Entering the number of modules
1. Double-click on the SmartRelay entry in the matrix to open the settings.
2. Change to the [Configuration/Data] tab.
3. Click on the Extended configuration button.
9
The "Extended configuration" window will open.
4. Enter the number of modules.
5. Click on the OK button.
9
Window closes.
6. Click on the Apply button.
7. Click on the Exit button.
8. Execute programming.
9
The number of modules is set.
10.3 Configuring the address for modules
Each connected module is actuated using its address. This address is set
on the address switch. If you connect a SmartOutput module to a
SmartRelay 3, set the following addresses:
Module
Address
Module 1
0 (initial setting in the factory)
Module 2
1
Module 3
2
Module 4
3
Module 5
4
Module 6
5
Module 7
6
SOM + SREL3.ADV
(Manual)
10. Programming and configuration
18 / 27
