Simoniz S1900, Инструкция по эксплуатации

Страница: 9 / 24

ASSEMBLY AND OPERATING INSTRUCTIONS
Step 1
Insert handle frame into pressure washer. Tighten
three screws from behind as shown.
Step 2
Attach top and bottom cord supports onto the
pressure washer.
Step 3
Attach gun holder (top) and gun holster (bottom)
onto the pressure washer. Secure the gun holder
with the screw.
Always prevent debris from being
drawn into the unit by using a clean
water source and an accessory water
filter if required.
Step 4 (First time use only)
Remove the covers. Separate quick-connect
coupling assembly (14 and 15). Attach inlet
adaptor (15) to inlet and attach quick-connect
coupling (14) to garden hose.
Fig.1 Fig.2
14 15
Fig.3 Fig.4
8
Water Supply (Cold Water Only)
•
Do not draw non-water liquids through the
unit. For use with cold water supply only.
•
Water hose must be at least a 1/2”
in diameter.
•
Flow rate of water supply must not fall below
2 GPM (gallons per minute).
•
Flow rate can be determined by running
the water for one minute into an empty
5-gallon container.
•
The water supply temperature must not
exceed 40°C (104°F).
Caution
•
Never use the pressure washer to draw
in water contaminated with solvents
(e.g. paint thinners, gasoline, oil, etc.).
•
Dirt in the feed water will damage the
unit. To avoid this risk, we recommend
checking the water filter (located inside
the water inlet; to clean it out see
Maintenance section).
•