22
TROUBLESHOOTING
– continued
Symptom
Cause
Solution
IF YOU ENCOUNTER ANY ADDITIONAL DIFFICULTIES NOT LISTED, PLEASE CALL
CUSTOMER SERVICE AT 1-866-4SIMONIZ (1-866-474-6664) FOR HELP.
No detergent.
Garden hose
connection leaks.
Spray wand, or
extension, or
nozzle leaks.
Pump is noisy.
Water leaks from
pump (up to 10
drops per minute
is permissible).
Oil Drip.
Motor buzzes
but fails to run.
Detergent container is empty.
Detergent bottle or suction
tube not properly connected.
Detergent is too thick.
Filter on detergent suction
tube is clogged.
Damaged or clogged
detergent suction tube.
Nozzle is in high-pressure position.
Discharge nozzle is obstructed.
Loose fittings.
Missing/worn rubber washer.
Spray nozzle not properly attached.
Broken o-ring or plastic insert.
Pump is sucking air.
Loose fittings.
Water seals are damaged or worn.
Oil seals are damaged or worn.
Supply voltage below minimum.
System has residual pressure.
Voltage loss due to extension cord.
Pressure washer not
used for long periods.
Add more detergent.
Check connections.
Dilute detergent.
Run warm water through
filter to remove debris.
Remove obstruction or
replace detergent suction tube.
Turn nozzle tip to
low-pressure position.
Blow out or remove debris
with a fine needle.
Tighten fittings.
Insert new washer.
Insert the spray nozzle into the trigger
gun. Carefully press in against the
spring tension and twist into the
locked position.
Call Customer Service.
Check that hoses and fittings are air
tight. Turn off machine and purge
pump by squeezing trigger gun until a
steady flow of water emerges through
the nozzle.
Check that all fittings are tight.
Call Customer Service.
Call Customer Service.
Verify that only the pressure washer is
running on this circuit.
Turn unit “OFF”, squeeze trigger on
spray want to release pressure, then
turn unit “ON”.
Do not use extension cord with this
unit—plug directly into power outlet.
Call Customer Service.
Содержание S1900
Страница 24: ......
