6
●
Do not incinerate the battery pack.
It
can explode in a fire.
●
Minor leakage from the battery pack
may occur under extreme usage,
charging or temperature conditions.
This does not indicate a failure. If,
however, the outer seal is broken and
this leakage gets on your skin, follow
these steps:
1. Wash immediately with soap and
water.
2. Neutralize with a mild acid such
as lemon juice or vinegar.
3. If liquid gets into your eyes, flush
immediately with clean water for a
minimum of 10 minutes and seek
medical attention.
NOTE: The battery fluid is a
20
–35% solution of potassium
hydroxide.
●
Do not use an extension cord.
Plug
the charger cord directly into an
electrical outlet.
●
Use the charger only in a standard
110
–120 V/60 Hz electrical outlet.
●
WARNING:
The double-
insulated charger is equipped with a
polarized plug (one blade is wider
than the other). This plug will fit into
a polarized outlet only one way. If
the plug does not fit fully into the
outlet, reverse the plug. If it still
does not fit, contact a qualified
electrician to install a polarized
outlet. Do not alter the plug in any
way. Double insulation eliminates
the need for the three-prong
grounded power cord and grounded
power supply system.
●
Charge the battery pack only with
the charger supplied with the tool.
●
Do not use the charger in wet or
damp conditions.
It is intended for
indoor use only. Do not use the
charger near sinks or tubs. Do not
immerse the charger in water.
●
Do not allow the charger cord to
hang over the edge of a table or
counter or touch hot surfaces.
The
charger should be placed away from
sinks and hot surfaces.
●
Do not use charger to charge any
batteries other than the
polisher/sander battery.
Other
batteries may explode.
●
Do not operate charger if cord or
plug is damaged.
Replace damaged
cord and plug immediately.
●
Do not operate charger if it has
received a sharp impact, been
dropped or otherwise damaged in
any way.
Have a qualified technician
examine the charger and repair it if
necessary. Do not disassemble the
charger.
●
For best results, only charge the
battery when the temperature range of
the battery and work area is between
10
–40°C (50–105°F).
●
Unplug the charger when not in use
and before cleaning or
maintenance.
SAVE THESE INSTRUCTIONS FOR REFERENCE
!
BATTERY & CHARGER SAFETY
Содержание 39-9049-2
Страница 19: ...19 PARTS DIAGRAM MODEL 39 9049 2 ...