Simoniz 39-9049-2, Руководство пользователя

Страница: 11 / 20

11
CHARGING THE BATTERY
– cont’d
1. Plug the small plug (1) of the charger
(2) into the receptacle (3) on the side
of the charging stand (4) (see Fig 3).
2. Plug the charger into a 115 V AC
power source.
3. Insert the battery fully into the cavity of
the charging stand.
NOTES:
a) Align the raised rib of the battery (5)
with the matching slot (6) in the front of
the charging stand cavity before
inserting the battery. If the battery
does not fit into the charging stand
cavity easily, check to make sure the
raised rib of the battery is toward the
front of the charging stand.
b) When fully inserted into the
charging stand cavity the red indicator
light (7) will come ON. If the light does
not come ON, the battery or the
charger is defective and must be
replaced with a new one.
4. After charging the battery for 3 to 4
hours, remove the battery from the
charging stand and unplug the charger
from the power source.
BATTERY & CHARGER FACTS
1. The battery supplied with the tool is
NOT fully charged when shipped. The
battery must be charged for at least 5
hours before being used in the
polisher.
2. There are two conditions under which
a battery will not accept a full charge:
●
when the battery is new
●
when the battery has not been
used for an extended period of
time.
These are normal conditions and do
not indicate a problem. After about four
cycles of charging and discharging
through use, the battery will accept a
full charge.
USING POLISHER/SANDER WITH 12 V
ADAPTOR AND CORD
You can power the polisher/sander with
your car battery by using the 12 V adaptor
and cord instead of using the tool battery.
1. Remove battery from the tool.
NOTE:
Refer to “removing & installing
battery” instructions on Page 10.
2. Install battery adaptor (1) into the tool
handle (2) (see Fig 4).
NOTE: Make sure the polarity symbols
(+ / -) on the adaptor match up with the
same symbols on the tool handle.
3. Insert the small plug of the 12 V cord
(3) into the end of the adaptor (4) and
the large plug of the 12 V cord (5) into
the accessory receptacle of your car.
BATTERY CHARGING & INSTALLATION
Fig. 3
Fig. 4