Simoniz 39-9049-2, Руководство пользователя

Страница: 10 / 20

10
Have you read “POWER TOOL
SAFETY”, “SPECIFIC SAFETY
RULES”, “BATTERY & CHARGER
SAFETY” and “SYMBOLS” on pages
3, 4, 5, 6 & 7 of this Manual? If not,
please do so now before you operate
this tool. Your safety depends on it!
Every time you use the polisher/
sander you should verify the
following:
1. Accessory is firmly installed &
centred on the mounting plate
2. Proper eye and breathing
protection are being worn.
Failure to adhere to these safety
rules can greatly increase the
chances of injury.
REMOVING & INSTALLING BATTERY
WARNING:
Always make sure your
fingers are away from the ON/OFF switch
when removing or installing a battery.
1. To remove the battery from the tool,
squeeze the locking buttons (1) on
each side of the battery (see Fig. 1).
2. Slide the battery (2) completely out of
the tool.
3. To install a battery, align the negative
polarity symbol (3) and the raised key
(4) on the battery with the negative
polarity symbol (5) on the tool handle
(see Fig. 2).
4. Slide the battery fully into the tool
handle until you hear the locking
latches (6) “click” into place.
NOTE: The battery will not fit into the
tool if the negative polarity symbols are
not aligned. If you encounter difficulty
inserting the battery into the tool,
check to make sure the negative
polarity symbols are aligned.
5. Gently pull on the battery to ensure it
is securely latched into the tool.
CHARGING THE BATTERY
Before beginning any polishing or sanding
project, it is important that you fully charge
the battery. As it takes 3 to 4 hours to fully
charge a run down battery, it is
recommended that the battery be charged
the day before being used.
WARNING:
Use ONLY the 12 Volt
charger supplied with this tool to charge
the battery. Do not charge any other
batteries with the charger supplied with
this tool. Mixing incompatible batteries
and charger may cause the battery to
leak or burst causing personal injury.
WARNING
!
BATTERY CHARGING & INSTALLATION
!
Fig. 1
Fig. 2
!