Guidelines:
• User awareness instructions should accompany the device when transferred to
other users.
• This radio meets the FCC RF exposure guidelines when used with the Simoco
accessories supplied or designated for the product. The designated Simoco belt
clip type is PAR-600CLIP and the extension speaker microphone types are
PAR-9180LMS2-2, PAR-9180LMW1 and PAR-600LMS4. Use of other accessories
may not ensure compliance with the FCC’s RF exposure guidelines and may violate
FCC regulations.
• Do not use this device if the operational requirements described herein are not
met.
Instructions:
• The radio transmitter power output is 5 Watts for PTT controlled, held-to-face or
bodyworn applications in analogue systems, or for DMR systems, 5 Watts burst
power.
• For radios enabled for held-to-ear Duplex operation in DMR systems, the
transmitter power output is 2.5 Watts burst power.
• For operation in held-to-face or bodyworn applications, transmit no more than
the rated duty factor of 50% of the time. To transmit (talk), push the Push-To-Talk
(PTT) button. To receive calls (listen), release the PTT button. Transmitting 50% of
the time, or less, is important because the radio generates measurable RF energy
exposure only when transmitting (in terms of measuring for standards compliance).
• For operation in DMR systems using Duplex held-to-ear applications, PTT control
is not required, but calls should always be kept as short as possible.
• Do not operate the radio without an approved antenna attached, as this may
cause the FCC RF exposure limits to be exceeded. With this product, only use an
antenna supplied or approved by Simoco.
• When using the radio in Handheld in front of face position, always keep the radio
at least 5 cm (2.0 inches) from the face when transmitting. When using the radio in
a Bodyworn position, use only Simoco accessories that will ensure the correct
compliance distance of at least 12 mm (0.45 inches) from the body. This radio has
been tested for RF exposure compliance at the distances listed in Table 1.
• For held-to-ear Duplex applications in DMR systems, the radio has been tested
for RF exposure compliance as listed in Table 2
Doc Number:
TNM-U-E-0114 ISSUE 1.4
Page
17