21
Camera won’t power up
Make sure that you have installed a full set of batteries in the
1.
battery compartment. Model 119326C can use either 4 or 8 AA
batteries.
Model 119318C must have a full set of 8 AA batteries
installed.
Simmons recommends using Energizer® Alkaline or
Lithium batteries in this Trail Cam.
Make sure that the batteries are installed correctly, observing
2.
proper polarity. Always place the negative (flat) end of each
battery in contact with the spring side of its slot inside the
camera.
Still Photo and/or Video Quality Problems
1. Night photos or videos appear too dark
a. Try using a set of new batteries. The flash will stop operating
near the end of the battery life.
b. You will get the best results when the subject is within the
ideal flash range, no farther than 45’ (13.7m) from the camera.
Subjects may appear too dark at greater distances.
c. Please note that when the image capture switch is set to
“Mul”, or with very short trigger delay settings, some images may
appear darker than others due to the quick response and rapid
retriggering of the camera, allowing less time for the flash to fully
recharge before firing again.
2. Daytime photos or videos appear too dark
a. Make sure that the camera is not aimed at the sun or other
light sources during the day, as this may cause the auto exposure
to produce darker results.
3. Night photos or videos appear too bright
a. You will get the best results when the subject is within the ideal
flash range, no closer than 10’ (3m) from the camera. Subjects
may appear too light at closer distances.
4. Daytime photos or videos appear too bright
a. Make sure that the camera is not aimed at the sun or other
light sources during the day.
Troubleshooting / FAQ
Содержание 119318C
Страница 2: ......
