OSW/SimuCube
The OSW mounting plate is designed to fit the dash on the most commonly Midge based direct
drives. The various slot holes can be used to slightly change the mounting height based on your own
preference.
Mounting
Bolt the adapter plate to the dash using the two supplied M5 bolts
Place the dash in the just created gap and fasten the bolts again.
Plug the supplied USB cable into the connector on the back of the dash and plug it in to a free USB
port on your computer. Continue to the driver and software section of this manual.
4. Drivers
A driver will be available on the Sim-Lab website. Install this driver to recognize the USBD480 screen.
Open the installer and follow the steps below:
Press “Next >”
Step 1.
Carefully loosen the two upper bolts on your motor. Loosen them just enough to fit the mounting
plate between the bolts and the front mount.