Simex SRT-L70, Руководство пользователя

Страница: 19 / 36

User manual - METER SRT-L70
a moment only, if [^] is pressed and held while button [v] is still pressed the decreasing slow
down and will be kept on lower speed.
Press [ENTER] at least 2 seconds to accept the changes, after that question ”Set?” is
displayed, and user must to confirm (or cancel) the changes. To conform changes (and story it
in EEPROM) press
[ENTER] button shortly after ”SEt?” is displayed. To cancel the changes
press
[ESC]
button shortly after
”SEt?”
is displayed. After that device returns to the menu.
7.2.3. Switch parameters (“LIST” type)
Switch parameters can be described as a sets of values (a lists) out of which only one of
the options available on the list can be selected for the given parameter. Options of switching
parameter are selected using
[^] , [v]
keys.
Short pressing of
[ENTER]
causes in displaying of the acknowledge question (
”SEt?”
). If
key
[ENTER]
is pressed again, the changes are accepted, stored in EEPROM end the edition
process finished. Pressing the key
[ESC]
after
”SEt?”
causes in cancelling of made changes
and returning to menu.
Functions of buttons when editing numeric and switching parameters:
Change of current (flashing) digit value while editing numeric parameter, or
value of switch parameter.
If numerical parameter is being edited, a short press of [ENTER / R2] button
change edited position. A long press of [ENTER / R2] button (at lest 2 sec.)
causes of display a ”SEt?” ask, which allow user to make sure if change of
the parameter value is correct. If switch parameter is being edited, a short
press of
[ENTER / R2]
button causes of display a
”SEt?”
ask. When
[ENTER / R2]
button is pressed again (while
”SEt?”
is displayed) the new
value of the parameter is stored in EEPROM memory.
Pressing this button operator can cancel the changes done up to now (if they
were not approved by
[ENTER / R2] button after the ”SEt?” ask) and come
back to menu
7.3. MENU DESCRIPTION
“- - - -” - password checking. If some password different from „ 0000 ” is set, then every
enter to main menu follows the entering of password. If entered password is
correct then first menu position will be displayed else warning ”
Err
”, and unit
returns to measurement mode.
Due to problem with direct displaying of “ m ” and “ K ” letters, they are exchanged
with special signs “ “ for “m” and “ “ for K respectively. However, in user manual
letters „
m ” and “ K ” are used to make it more readable (example: “modE”, “tc K” ).
19
i
R2
ENTER
R1
ESC