Sime MURELLE HM, Руководство пользователя

Страница: 112 / 120

4.6 FUNCTIONING ANOMALIES
When there is a functioning anomaly, an
alarm appears on the display
and the blue
luminous bar becomes red.
Descriptions of the anomalies with relative
alarms and solutions are given below:
– LOW WATER PRESSURE ANOMALY
ALARM 02 (fig. 23/1)
If the pressure detected by the transdu-
cer is lower than 0.5 bar, the boiler
stops and the display shows the alarm
ALL 02.
Bring the pressure back to normal by
means by acting on the loading knob
(whereas, in vers.
25 T – 35 T , from
appropriate load connection externally
mounted by the installer) until the pres-
sure indicated by the transducer is
between 1 and 1.5 bars.
WHEN FILLING HAS BEEN COMPLETED,
CLOSE THE KNOB BY TURNING IT
CLOCKWISE.
If the load procedure has to be repea-
ted several times, it is advisable to
check that the seal of the heating cir-
cuit is intact (check that there are no
leaks).
– HIGH WATER PRESSURE ANOMALY
ALARM 03 (fig. 23/2)
If the pressure detected by the transdu-
cer is more than 2.8 bar, the boiler
stops and the display shows anomaly
ALL 03.
112
APRE
Fig. 23/1
OPEN
4.5.4 WILO-YONOS PARA PWM pump diagnose and remedy (fig. 22/b)
Fig. 22/b
LED
LED diagnose and remedy
Led color
Continuous green
Meaning
Normal running
Diagnostic
Pump run as expec-
ted or is faced to a
phenomenon that
shortly affects its
running
Cause
Normal operation
Remedy
Red/green blinking Abnormal situation
(pump functional
but stopped) Pump will restart
by itself after the
abnormal situation
disappeared 1. Undervoltage or
Overvoltage:
U<160V or U> 253V
2. Module overvoltage:
T° inside motor too high
1. Check voltage supply:
195V<U<253V
2. Check water & ambient
T°
Red blinking
Stopped (e.g. pump
blocked) Reset the pump
Check LED signal Pump cannot restart itself
due to a permanent failure Change pump
No LED No power supply No voltage
on electronics 1) Pump is not connected
to power supply
2) LED is damaged
3) Electronics are damaged
1) Check cable connection
2) Check if pump is runnning
3) Change pump
Fig. 23/2