Sime FORMAT DGT 25/55, Руководство пользователя

Страница: 85 / 88

85
ES
PT
ENG
ANOMALIES AND SOLUTIONS
When there is a functioning anomaly, the
display controls shows
and red led switch
on .
Descriptions of the anomalies with the rela-
tive alarms and solutions are given below:
– AL 01 (fig. 29)
Press the key of the controls to re-
start the boiler.
If the anomaly persists, request the
intervention of qualified technical per-
sonnel.
– AL 02 (fig. 29/a)
If the pressure detected by the water
pressure valve is lower than 0.5 bar, the
boiler stops and the display shows the
alarm “AL 02”.
Proceed to the restoration of load pres-
sure knob until the pressure indicated
dall'idrometro will be between 1 to 1.5
bar.
AFTER FILLING CLOSE THE WHEEL
LOAD.
If it is necessary to repeat the system
loading procedure, it is advisable to
contact qualified technical personnel
to check the seal of the heating system
(to check whether there are any leaks).
– AL 04
Request assistance from qualified
technical personnel.
– AL 05
Request assistance from qualified
technical personnel.
– AL 06 (fig. 29/b)
Press the key of the controls to re-
start the boiler.
If the anomaly persists, request assi-
stance from qualified technical person-
nel.
– AL 07 (fig. 29/c)
Press the key of the controls to re-
start the boiler.
If the anomaly persists, request assi-
stance from qualified technical person-
nel.
– AL 08
Request assistance from qualified
technical personnel.
– AL 10
Request assistance from qualified
technical personnel.
– AL 11
Request assistance from qualified
technical personnel.
– AL 12
Request assistance from qualified
technical personnel.
Fig. 29
Fig. 29/a
Apre
0 4
1 3
2
bar
OPEN
Fig. 29/b
Fig. 29/c