Mounting
The Aerostat XC2 comes with a mounting stand preassembled to the blower. The
mounting stand is designed for a free or fixed position on a tabletop or workbench
and mounting to a fixed surface. Self-adhesive skid-resistant rubber feet are supplied
with the blower and installed on the bottom of the stand by the end-user. Holes in
the base of the stand are provided for securing the XC2 to a fixed location using
5/16" (8 mm) diameter screw hardware (not provided).
Once the Aerostat XC2 is secured to a surface, the mounting stand can be adjusted
and locked to the desired position. Loosen, but do not completely remove, the knobs
on each side of the blower. Tilt the XC2 to the desired position, so the XC2 ionized
airstream is aimed directly at the target with no intervening grounded objects.
Re-tighten the knobs to lock the XC2 into place.
Power Connections
The XC2 accepts universal AC input (100-230 VAC 50/60
Hz single-phase). The XC2 must be grounded for safe and
proper operation. The XC2 is available with different line
cords to meet the main power connection plug requirements
in many areas. Connect the supplied power cord to an
appropriate 3-terminal grounded AC power receptacle.
CAUTION
– Using a non-grounded power cord, if used
improperly, can cause unpredictable XC2 behavior,
such-as intermittent activation of the XC2's alarm.
Care must be taken to ensure the XC2's "LINE" and
"NEUTRAL" AC input is properly connected to the
"LINE" and "NEUTRAL" of the utility power.
If installing the XC2 Blower in an electrically noisy environment, an additional
ground connection can be made to the blower using the convenience ground
terminal located on the blower's rear panel.
A cord clamp is supplied with the blower.
Use this cord clamp to prevent unwanted
disconnection of the power cord or protect
against the power cord's accidental loosening
due to vibration.
After connecting the power cord to the power inlet
connector, fit the power cord through the cord
clamp and secure the clamp to the rear chassis
panel with the supplied #6 sheet metal screw.
WARNING – Electric Shock Hazard
Do not insert anything within the intake or outlet grills. Electric shock may
result.
Figure 5. Ground Terminal
Figure 6. Power Cord Clamp
8
Aerostat XC2
5201333 Rev. A
