short spray nozzle on the machine body, as shown in Figure 1. Fix the straight nozzle
on the machine body. To remove the straight nozzle, please rotate the straight
nozzle inversely (counterclockwise) as shown in Figure 2, and align the arrow on the
straight nozzle with the single-line mark on the machine body. Then the straight
nozzle can be pulled out.
For direct installation on short spray nozzle, aim the spray
nozzle with round brush or bent spray nozzle at the top of
spray nozzle, as shown in Figure 3, and push the spray nozzle
upwards until it is in position. As the short spray nozzle and
spray nozzle are positioned in six directions, the angle and
direction can be adjusted during the installation. Or, first
install long spray nozzle and then the spray nozzle with round
brush or bent spray nozzle. The long spray nozzle is installed in
the same method as the installation of straight nozzle. The
spray cup with round brush or bent spray cup and long spray
nozzle can be installed in the same procedures as the
installation on short spray nozzle.
3. Installation of window cleaning attachment for door/window
First install the fabric nozzle on short spray nozzle
As shown in Figure 4 and Figure 5, install the two small hooks of window cleaning
attachment onto suspension lugs of the fabric nozzle, and then trigger the big hook
of the window cleaning attachment, and push the window cleaning attachment
and clutch it onto the body of fabric nozzle.
4. Ironing brush
To iron a chair, sofa, bed, etc, place the white towel sleeve on fabric nozzle and
connect with the short spray nozzle.
Refill water during operation
1. Unplug the power cord and disconnect the power supply
2. Press down the steam button to release the pressure until no steam is injected out.
3. Slowly unscrew the safety cap but do not remove it, and residual steam will be
discharged slowly until no steam comes out. Then place the machine in a cool
place to cool it down for about five minutes. Finally, completely remove the
safety cap.
4. Use the funnel and measuring cup to refill a suitable quantity of cold or hot water
into the tank.
5. Re-install the safety cap onto the machine body and tighten it in position.
2. Install spray nozzle with round brush or bent spray nozzle
- 05 -
- 06 -
