21
If you are using a MOON CD Transport or CD Player such
as the MOON 260D with your 240i you should make a
SimLink™ connection between the “CD’s SimLink™ out and
the 240i’s SimLink™ in. The default input is the “SPDIF 1”
which means that when you press the
(play) button on
the CD, the 240i will automatically switch to the “SPDIF 1”
input. You can change the default for the “MOON CD” using
the previously described SETUP software.
The connection rules for the SimLink™ are very
straightforward. You must always connect the supplied
cable between one component’s “SimLink™ Out” jack
and another component’s “SimLink™ In” jack.
There is no master component in a SimLink™ chain;
no particular component operates as the main
communications controller.
Operating the 240i
We recommend leaving your MOON 240i powered up at
all times to maintain optimal performance. When you plan
on being away for a few days, it may not be a bad idea
to power off your integrated amplifier.
Turning on the MOON 240i for the first time
Prior to turning the 240i on for the first time, make sure
that every cable is properly connected to avoid any
problems. Flick the main rocker switch, located on the rear
panel, labeled “POWER” to the ‘1’ (on) position. Next, briefly
press the push button labeled “Standby” located on the front
panel. The blue LED on the front panel will illuminate and
an animated screen will appear in the display for five (5)
seconds while the 240i goes through its start-up procedure:
This occurs every time you power up your 240i
via “Standby”. Then you will hear a very faint single
clicking sound confirming that everything is in order
and that the 240i is now ready for use.
On and Off sequence
To avoid hearing any annoying noises (ie. “thumps”
and “pops”) emanate from your speakers you
should always first power up any devices connected
to the 240i prior to powering up the 240i. When
powering off your 240i always power down your 240i
before powering down any components connected
to the 240i.
One feature of SimLink™ on the MOON 240i, involves
the “Standby” function. By pressing down and holding
the “Standby” button for 2 seconds on the 240i, all
other MOON components connected via the
SimLink
TM
will go into “Standby” mode along with
the 240i. The same logic applies when switching
from “Standby” to active mode.
Содержание Moon 240i
