Sima AMBAR 200, Оригинальное руководство пользователя

Страница: 26 / 52

ENGLISH
-10-
10.2 REALISING A STRAIGHT CUT
Right cutting is realised as follows:
1 Make sure the cutting height matches the mounted blade. The blade should protrude with 3 to 5 mm below
the material to be cut, without touching the front and back cutting table reinforcements.
2 Place the piece to be cut on the cutting table making sure it remains stable and laying against the front
ruler of the cutting table.
3 Once the height of the cutting head has been adjusted and the piece placed on the cutting table, start-up
the engine and make sure the cooling is adequate to the blade and material to cut. Using the handle that embodies
the blade safety guard, drag the cutting head until the blade touches the piece to cut. You need to start cutting slowly
and maintain a constant progress in function of the material to be cut.
10.3 REALISING A 45º CUT
AMBAR 200 has been designed in a way that the frame of the cutting bridge supports the cutting head, allows
its inclination and makes cuts at 45º.
WARNING: Always incline the cutting bridge with motor switched off.
Loosen the blocking controls on both sides of the machine. Incline the cutting bridge to select the desired
angle as per the graduated scale located in front of the water tray. Make it face the written side of the set square until
we achieve the desired degrees visualising this angle in the graduated scale.
Fasten back the blocking controls. Afterwards, proceed as per the straight cut instructions.
10.4 REALISING A DIAGONAL CUT
Diagonal cutting is effectuated in the same way as a right cutting:
For a diagonal cutting, you need to use the ruler with a graduated semicircle that is supplied with the
machine. This ruler must rotate to look for required degrees to make the cutting. It has a blocking screw to fix the
desired position. Once the degrees have been selected in the semicircle, you place the piece to cut on the cutting table
marking the face of the graduated ruler as well as the front ruler upper face. To complete the cutting, proceed as per
the straight cut instructions.
11. MAINTENANCE
AMBAR 200 models require a basic maintenance as follow:
• Change the water in the tray and clean the machine as often as necessary. The tray has a drain outlet for that
purpose. The filling level must cover the pump completely.
• Even the cooling pump has a filter cap, it could happened the dust and detritus of cutting material block the
propeller. In order to prevent it periodically run the pump in a container with clean water for a few minutes. May be
necessary to remove cover and clean the filter until the propeller turbine spins freely.
• Remove any traces of material from the tracks of the aluminium sliding cutting bridge head, and lubricate the tracks
with consistent oil
• In case of electrical wire cuts, deterioration or break, replace as soon as possible.
• If the machine is not covered, cover it with waterproof material.
• At the end of each day, turn off the machine and disconnect.
Maintenance operations should be carried out preferably by persons who know the machine and its operation.
Any manipulation of the machine should be provided with the engine switched off and unplugged cable. Be
sure to remove completely any tools from the cutting area.
In case of anomalies or malfunctions, the machine should be check by a trained technician.