Sim2 SVD800 HD Millennium, Руководство по обслуживанию

Страница: 9 / 43

SVD800HD
SERVICE GUIDE
page - 9 -
PC121 SHIFT BOARD
A section includes the adjustments pre-set in the Factory.
B section includes the adjustments to be performed in service when the unit is replaced.
A section (Factory adjustments)
1. Turn anticlockwise the cores of L1 and L5 till come out for about 1.5 cm.
2. Turn anticlockwise the core of L3 till come out for about 1 cm.
3. Select CROSS pattern.
4. Reset convergence values, using RESET ZONE (see user manual)
5. Select ZONE
6. Centre the Green raster looking through the lenses, using SHIFT control.
7. Centre the Red raster looking through the lenses, using SHIFT control.
8. Centre the Blue raster looking through the lenses, using SHIFT control.
9. Select HATCH COARSE pattern.
10. Move horizontally the Blue and Red tubes to superimpose the vertical central lines.
11. Select HATCH FINE pattern.
12. Switch-off B tube.
13. Adjust L1 to have a symmetrical convergence error of the RED at the sides (see following figure)
14. Switch-off R tube and switch-on the B tube.
15. Adjust L5 to have a symmetrical convergence error of the BLUE at the sides (see following figure)
R G B B G R
B section: service adjustments are not requested.