Sim2 SVD800 HD Millennium, Руководство по обслуживанию

Страница: 32 / 43

SVD800HD
SERVICE GUIDE
page - 32 -
7. SDG UPC2000 INSTALLATION PROCEDURE
•
Check the projector EEprom release : press the INFO key on the remote control and read the “SOFTWARE REL.”
on page 2/2. If SOFTWARE REL. is 6.04 or lower, replace the EEprom using the one supplied in the kit,
otherwise nothing has to be done.
•
Switch off the projector and remove the power cable
•
Remove the top plastic cover (see: par. 4.2.1 page 16 of the Instruction Manual).
•
Remove the top aluminum cover (A) by unscrewing 8 screws (B).
•
Remove the bottom aluminum cover (C) by unscrewing 6 screws (D).
•
Unscrew the 2 screws (E) at the side of the convergence heat sink and lift it.
•
Unscrew the screws (F) on the top of the UPC holder.
•
Insert UPC in the channels (G) and press it down.
•
Replace EEprom if necessary : unscrew the screws and remove the aluminum cover of microprocessor board
PC328 (the board is vertically mounted near the UPC board), extract the board, find out the integrated circuit
labeled IC29, replace IC29 with the other one provided in the up-converter kit.
•
Remount the microprocessor board
•
Reposition all the aluminum cover and the screws.
•
NOTE: When repositioning the bottom aluminum cover be careful to insert correctly the two LED 21 e 22 in the
holes (see page 6 pict. 3 of the Instruction Manual).
•
Close the top plastic cover and the two screws.
•
In order to use the UPC converter with the RC3100 remote see par. 3 page 8 and par. 3.14 page 11 of the
Instruction Manual, and with the RC3000 remote, see par.5 page 25 of the Instruct. Manual.