Silvercrest SZM 500 A1, Инструкции по эксплуатации и безопасности

Страница: 12 / 55

10 GB
NOTES:
Only use 1 scoop at a time to avoid overfilling
and spilling the sugar out .
Do not use the product for longer than 15 minutes
without stopping . The product could overheat and
be damaged . Switch off the product and allow it
to cool down for at least 15 minutes .
Set the on/off switch 13 to I .
After a short while sugar strands will start to form
around the inner edge of the bowl 3 .
Guide the bamboo stick 6 in circles around
the sugar container 2 . While doing so, turn the
bamboo stick 6 in your fingers .
As soon as the sugar strand adheres to the
bamboo stick 6 lift the stick above the bowl 3
area .
Hold the bamboo stick 6 horizontally right
above the bowl 3 while turning it in your fingers
continuously .
Slowly move the bamboo stick 6 around the
edge of the bowl 3 to keep collecting all the
sugar strands .
The sugar is used up when no more strands
appear .
If you want to prepare more candy floss, switch
the product off . Refill the sugar container 2 .
˜
After use
Switching off: Set the on/off switch 13 to O .
Wait until the product cools down .
Clean the product thoroughly .
NOTE: Clean the product after every use,
otherwise the sugar residues may cause defects
in operation .
˜
Thermal cutoff
The product is equipped with a thermal cutoff sensor .
If the temperature gets too high and there is a risk of
damage the product switches off automatically . Once
that happens, take the following measures:
Disconnect the power plug 11 from the power
socket immediately .
Have the product checked by qualified personnel .
˜
Troubleshooting
Problem Cause/Solution
Water entered the
base unit .
Disconnect the power plug 11 from the power socket .
Flip the base 1 over and leave it to drain .
Have the product checked by a qualified personnel .
Sugar entered the
base unit .
Disconnect the power plug 11 from the power socket .
Allow the product to cool down .
Remove the sugar container 2 from the drive shaft 8 .
Flip the bottom section over . Gently shake the product letting the sugar trickle out .
The sugar container
is not turning .
Check if the sugar container 2 is placed correctly (see "Assembly") .
No sugar strands
are forming .
The sugar container 2 might be jammed . Clean the container thoroughly .
The product
suddenly stops
working .
The product was in operation for too long activating the thermal cutoff
(see "Thermal cutoff") .
Disconnect the power plug 11 from the power socket . Have the product checked
by qualified personnel .