Silvercrest SZM 500 A1, Инструкции по эксплуатации и безопасности

Страница: 11 / 55

9 GB
Do not pull the power plug out
of the electrical outlet by the
power cord and do not wrap the
power cord around the product .
Connect the power plug to an
easily reachable electrical outlet
so that in case of an emergency
the product can be unplugged
immediately .
Do not touch the moving parts .
Keep fingers, hair, clothing and
utensils away from all moving
parts .
Disconnect the power plug from
the power supply when the
product is not in use and before
cleaning .
Make sure that the location
planned for the usage of the
product is well ventilated .
Place the product on heat-resistant
surfaces only . Do not place on
carpets, bedding, towels etc .
Should unusual noise, smell,
smoke or other malfunctions arise
during use, switch the product
off and unplug it from the power
socket .
˜
Before use
˜
Unpacking
Remove the packaging . Check if all parts are
complete .
Clean the product before first use (see "Cleaning
and care") . Dry all parts thoroughly .
˜
Assembly
Fig. Step
Place the base unit 1 on a stable flat ground .
Avoid rugged surfaces to let the suction
cups 12 secure the base unit 1 position .
A
Place the bowl 3 onto the base unit 1 .
B
Turn the bowl 3 clockwise until it is secured
in place .
C
Place the splash guard 4 on the bowl 3 .
D
Align the edges of the splash guard 4 and
the bowl 3 . Secure both parts together with
the locking ring 5 .
E
Place the sugar container 2 on the drive
shaft 8 .
NOTE:
The cross pin on the drive
shaft 8 must fit into the indentation on
the bottom pin of the sugar container 2 .
˜
Operation
Connect the power plug 11 to a suitable mains
socket .
Switching on: Set the on/off switch 13 to I .
Allow the product to run for about 5 minutes to
reach the operational temperature .
Switching off: Set the on/off switch 13 to O .
Wait until the sugar container 2 stops turning .
Place approximately 14 g sugar (not included)
into the middle section of the sugar container 2
by using the measuring spoon 9 .