SilverCrest SSRM 10 A1
English - 21
Activating / deactivating the alarm function
When you have set the desired alarm time, you can activate the
alarm function as follows:
Briefly press the "MEM/AL" button (7) repeatedly when the
device is switched off until the desired alarm symbol (12,13) is
indicated with the corresponding alarm time on the display (1).
Both alarm times can also be activated together.
To deactivate the alarm function, briefly press the "MEM/AL"
button (7) until no alarm symbol (12,13) is indicated on the
display (1). The alarm function is then deactivated.
The device wakes you at the set alarm time with a signal tone.
The alarm tone then sounds for approx. 60 seconds, followed
by a snooze period of approx. 60 seconds. On the display
(1), the corresponding alarm symbol (12,13) flashes during
the snooze period. This sequence is repeated until the alarm
tone is switched off. To switch off the alarm tone, briefly press
the "On/Standby" button (6). The alarm is then deactivated
until the next day.
Please note that the signal tone is played via the built-
in buzzer of the scan radio and not via the
earphones.
SNOOZE function
To pause the alarm tone for approx. 5 minutes, briefly press
the "MODE" button (3) during the signal tone. During these 5
minutes, the corresponding alarm symbol (12,13) flashes on
the display (1) and the "SNOOZE" symbol (15) is indicated.
