Silvercrest SPWD 180 H1, Инструкция по эксплуатации и правила безопасности

Страница: 14 / 94

SilverCrest SPWD 180 H1
12 - English
9.3 "USEL" is indicated on the LCD display and the scales switch off

An error has occurred and the diagnostic scales cannot perform the measurement. In this
case, step off the tread (5) of the diagnostic scales and start the measurement again.
9.4 "Err" is indicated on the LCD display

Your weight exceeds the maximum load capacity of 180 kg / 396 lb / 28 st. You should
step off the tread (5) of the diagnostic scales immediately to avoid damaging the scales.
9.5 “Err2” is indicated on the LCD display

An error occurred during measurement. If this happens, step off the tread (5) on the
diagnostic scales and restart the measurement. Make sure that you are standing on the
electrodes (6).
10. Maintenance / cleaning
It is necessary to service the diagnostic scales if they have been damaged in any way, for example,
if the housing is damaged, if liquid or objects have penetrated the diagnostic scales or if they have
been exposed to rain or moisture. Servicing is also required if the device is not working properly or
has been dropped. If smoke is produced, or there are any unusual sounds or smells, remove the
battery immediately from the diagnostic scales. In such cases, the diagnostic scales should not be
used until they have been inspected by authorised service personnel. Only have qualified personnel
carry out the servicing on the device. Never open the housing of the diagnostic scales. Only use a
clean, dry cloth for cleaning and never use any corrosive liquids.