GB
│
IE
│
NI
│
11
■
SHAZ 22.2 B2
Operation
CAUTION!
►
The suction opening must always be kept free of blockages . Blockages lead
to overheating and damage to the motor .
NOTE
►
If the floor nozzle
8
is blocked so that the floor brush
0
can no longer
rotate, the appliance will switch off . The LEDs start to flash alternately . If
this happens, remove the blockage as described in the section “Cleaning
the floor brush” . Afterwards, you need to push and release the On/Off
switch
q
once before you can use the appliance again .
♦
If you have not already done so, disconnect the appliance from the mains
adapter
g
or lift it off the wall bracket
f
.
♦
Fit the required attachment as necessary . See also the section "Fitting/
removing attachments" .
♦
Press the On/Off switch
q
to switch the appliance on . As long as you hold
down the switch
q
, the appliance will keep running . The indicator light
3
lights up .
ECO mode
When possible, use the energy-efficient and low-noise ECO mode .
Press the ECO mode button
2
to activate ECO mode permanently .
The button lights up . This also works during operation .
Press the ECO mode button
2
again to deactivate ECO mode .
Cleaning
CAUTION! PROPERTY DAMAGE!
►
Do not use aggressive, chemical or abrasive cleaning agents . These could
damage the outer surfaces of the appliance .
Emptying the dirt container and cleaning the filter
NOTE
►
To achieve the best results, empty the dirt container
t
and clean the
HEPA filter
i
regularly .
♦
If you have not already done so, disconnect the appliance from the mains
adapter
g
or lift it off the wall bracket
f
.
♦
Disconnect the dirt container
t
from the hand element
4
by pushing the
"MOVE"
u
release button downwards and pulling off the dirt container
t
.
