GB
│
IE
│
NI
│
9
■
SHAZ 22.2 B2
♦
Select a suitable mounting location for the wall bracket
f
:
You must be able to easily place the handheld vacuum cleaner into the
bracket or remove it, and the mains socket must be easily accessible .
Ensure that the appliance is not exposed to direct sunlight or other heat
sources .
♦
Mark two drill holes on the wall at a distance of approx . 154 mm from each
other . Ensure that there is a mains power socket in the immediate vicinity .
♦
Use a 5 mm drill bit to drill the required holes and insert the wall
plugs .
♦
Screw in the screws so that the heads protrude a few millimetres . Hang
the wall bracket
f
on the two screws using the slotted holes on the rear .
Ensure that the screws slide into the two slots . The wall bracket
f
should lie
flush against the wall . You can adjust the distance to the wall and compen-
sate for any unevenness in the wall by screwing in or unscrewing the screws .
♦
You can place the nozzles on the accessories holder
d
on the side .
♦
Now plug the barrel plug
h
of the mains adapter into the top of the wall
bracket
f
and the mains adapter
g
into a wall socket .
Charging the batteries
■
The appliance runs on rechargeable lithium-ion batteries .
■
The indicator lamp
3
shows the charge level of the batteries (25%, 50%,
75%, 100%) . If the batteries are empty, all of the bars start to flash for a
few seconds before the appliance switches itself off .
■
There are two ways of charging the batteries .
–
Plug the barrel plug
h
of the mains adapter directly into the connection
1
on the appliance and the mains adapter
g
into a wall socket .
–
Plug the barrel plug
h
of the mains adapter directly into the connection
on the wall bracket
o
and the mains adapter
g
into a wall socket .
Hang the appliance into the wall bracket
f
so that the plastic tab on
the wall bracket
f
slides into the recess between the hand element
4
and the dirt container
t
. The contacts should now be connected to
each other .
NOTE
►
The appliance cannot be operated during charging .
■
Depending on the charge level, the current bar on the indicator lamp
3
will flash during charging . The charging process is completed when all four
bars light up .
